Skil PWRCORE 12 DL529001 Manual Del Propietário página 15

Install and Remove Bits
WARNING
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to grasp
the spinning chuck.
Your tool is equipped with a keyless chuck to
tighten or release drill bits in the chuck jaws.
The arrows on the chuck indicate the direction
in which to rotate the chuck body in order to
GRIP (tighten) or OPEN (release) the chuck
jaws on the drill bit.
a. Lock the trigger switch "OFF" on the tool by
placing the direction-of-rotation (forward/
center-lock/reverse) selector in the center
position.
b. Remove the battery pack and rotate the
torque-adjustment ring to the Drill Setting "
To install the bit:
c. Rotate the chuck body counterclockwise,
viewed from chuck end, to open the chuck to
approximately the drill bit diameter.
d. Insert a clean bit up to the drill-bit flutes for
small bits, or as far as it will go for large bits.
Close the chuck by rotating the chuck body
clockwise and securely tighten by hand
(Fig. 8).
To remove the bit:
e. Rotate the chuck body counterclockwise,
as viewed from the chuck end, to open the
chuck.
f. Remove the bit.
For 1/4'' hex bits:
Your tool is equipped with a built-in collet inside the chuck, making it very easy to install and
remove 1/4'' hex bits.
a. Lock the trigger switch "OFF" by placing the direction-of-rotation selector in the center
position.
b. Remove the battery pack.
c. To install the bit:
Insert the bit into the collet. You will hear a "click", indicating that the bit is securely installed
in place.
d. To remove the bit:
Pull the bit out of the collet (Fig.9).
WARNING
Do not use the power of
the drill while grasping
Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
Fig. 8
Keyless Chuck
Chuck
Jaws
GRIP
(tighten)
".
Fig. 9
OPEN
(release)
Chuck Body
15