Important Warnings - UFESA CP6105 Manual De Instrucciones

If the cord is damaged, it must be replaced by the
manufacturer, its after-sales service or by qualified persons
to prevent any hazards.

IMPORTANT WARNINGS

This appliance is designed for home use only and should never be used for commercial or industrial use
under any circumstances.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label.
Do not use this device near to bathtubs, showers, sinks or other tanks that contain water.
Do not use the appliance on wet hair.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not pull on the cable to unplug it or use it to carry the product.
Do not wrap the cable around the device.
Proceed according to the cleaning section of this manual for cleaning.
Do not use the product on animals.
Unplug the product immediately from the mains in the event of any breakdown and contact an authorised
Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from the
brand´s Official Technical support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and void. Only an
authorised technical support service centre may carry out repairs on this product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects,
for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Prior to turning on the device, remove the protective cover (D) and set the desired trimming brush (E), taking
it by the sides (fig.1) and adjusting the lower section of the blade. We recommend starting off by selecting
the longest one 12mm, then changing to the smaller ones 9, 6 or 3mm until you achieve the desired length.
In order to remove the cutting brush, pull upwards (fig. 2.)
Connect the product to the appropriate mains.
Turn on the product by selecting the on switch and placing it in the I (B) position.
Select the 0(B) on switch in order to turn off the product before you disconnect the device from the mains..
10