Description Of The Hood & Controls; Controls - ELICA LI30TA Guía De Instalación, Uso Y Mantenimiento

Description of the hood &

Controls

6
5
2
4
3
1. Blower and light controls
2. Lamp housings
3. Grease filter Handle
4. Grease filter
5. Duct covers
6. Louver holes (Only for Recirculating version)
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Note: Hood retains last speed setting when aspiration switch
is turned off.
Description of control panel
1
1. Light Button
. Timer Button
4
3. Display
4. "-" Button. Speed Decrease / OFF
5. "+" Button. Speed Increase / ON
10
• Press lamp button to turn ON the light on High Intensity
(Lamp state previously OFF).
• Press lamp button to turn ON the light on Low Intensity
(Lamp state previously ON).
• Press lamp button to turn OFF the light (Lamp state
previously ON).
• The default timer setting is 10 minutes, and it can be
adjusted between 60 minutes and 1 minute.
• After pressing the timer button, the control enters to a
timer setup mode, and user can adjust the timer
countdown time with the "+" and "-" buttons within 5
seconds. The timer can be initiated immediately
pressing the timer button, after setting the timer
duration or pressing the timer button twice (default 10
minutes setting).
• If no action occurs within 5 seconds, the countdown
will start.
• During the timer setup the "+" and "-" buttons are
dedicated to the timer and no motor action will occur.
• Once the timer is initiated, it can be cancelled by
pressing the timer button again.
• Shows the hood settings.
• The display will be lit at low intensity when the hood is
not operating.
• Pressing any key the display will light up at high intensity.
• The display will be lit at high intensity when the hood is
operating.
If no key is pressed within a minute the display will return
to being lit at low intensity.
• This button is used to decrease the fan speed, or turn
OFF the fan.
• The fan will turn OFF if the "-" button is pressed and the
hood was in the first speed.
• If the fan is at second speed and the "-" button is pressed,
the fan will be set to first speed.
• If the fan is at third speed and the "-" key is pressed,
the fan will be set to second speed.
• If the fan is at fourth speed and the "-" button is pressed,
the fan will be set to third speed.
• If the fan is OFF and the "-" button is pressed, the control
backlight will light up.
• This button is used to increase the fan speed, or turn
ON the fan.