Home Decorators Collection 51591 Guía De Uso Y Mantenimiento página 10

Assembly - Hanging the Fan (continued)
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket.
□
Secure with electrical tape.
5
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
□
Align the locking slots of the ceiling canopy (C) with the two
screws (DD) in the slide-on mounting bracket (A). Push up to
engage the slots, and turn clockwise to lock the canopy (C) in
place.
□
Firmly tighten the two mounting screws (DD).
□
Install the two mounting screws (saved from Assembly Step 1
"Preparing for mounting") into the holes in the canopy (C) and
tighten firmly.
□
Install the decorative canopy ring (I) by aligning the ring's
slots with the screws in the canopy (C). Rotate the canopy
ring (I) counterclockwise to lock it in place.
A
10
DD
I
E