Home Decorators Collection 51591 Guía De Uso Y Mantenimiento página 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. 15.9 kg) or less", and use screws provided with the
outlet box.
NOTE: The mounting bracket (A) is designed to slide into place
on an outlet box with the outlet box screws (JJ) installed.
□
Loosen the two mounting screws (JJ) in the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Slide the mounting bracket (A) on to the mounting screws (JJ)
and center the mounting bracket (A) in relation to the outlet box.
If necessary, use leveling washers (not included) between the
slide-on mounting bracket (A) and the outlet box. The flat side of
the slide-on mounting bracket (A) should face toward the outlet
box, as shown.
□
Securely tighten the two mounting screws (JJ).
2
Hanging the fan
WARNING: The hook (XX) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (XX) breaking, causing the fan to fall.
The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (XX) it is
critical that you use one of the non-slotted (round) holes in
the canopy (C).
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket (A) aligned
with the slot in the ball.
XX
8
A
B
C
D
E