Bosch PWS 20-230 Manual Original página 26

Ocultar thumbs Ver también para PWS 20-230:
Tabla de contenido

Publicidad

OBJ_BUCH-976-001.book Page 27 Monday, April 20, 2009 8:21 AM
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 3.
Screw the auxiliary handle 3 on the right or left
of the machine head depending on the working
method.
Vibration-dampening Auxiliary Handle
The vibration-dampening auxiliary handle reduc-
es the vibrations, making operation more com-
fortable and secure.
Do not make any alterations to the auxiliary
handle.
Do not continue to use an auxiliary handle if it
is damaged.
Hand Guard
For operations with the rubber sanding
plate 16 or with the cup brush/wheel
brush/flap disc, always mount the hand
guard 14.
The hand guard 14 is fastened with the auxiliary
handle 3.
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Clean the grinder spindle 4 and all parts to be
mounted.
For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock
button 1.
Actuate the spindle lock button only when
the grinder spindle is at a standstill. Other-
wise, the machine may become damaged.
Bosch Power Tools
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding
tools. The mounting hole diameter must fit the
mounting flange without play. Do not use reduc-
ers or adapters.
When using diamond cutting discs, pay atten-
tion that the direction-of-rotation arrow on the
diamond cutting disc and the direction of rota-
tion of the machine (see direction-of-rotation ar-
row on the machine head) agree.
See graphics page for the mounting sequence.
To fasten the grinding/cutting disc, screw on
the clamping nut 10 and tighten with the two-
pin spanner; see Section "Quick-clamping Nut ".
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn free-
ly. Make sure that the grinding tool does
not graze against the protection guard or
other parts.
An O-ring (plastic part) is in-
serted in the mounting flange 8
around the centring collar. If
the O-ring is missing or is
damaged, it must in all cases
be replaced (article number
1 600 210 039) before the
mounting flange 8 is mounted.
Flap Disc
For operations with the flap disc, always
mount the hand guard 14.
Rubber Sanding Plate
For operations with the rubber sanding
plate 16, always mount the hand guard 14.
See graphics page for the mounting sequence.
Before mounting the rubber sanding plate 16,
put the 2 spacer discs 15 onto the grinder spin-
dle 4.
Screw on the round nut 18 and tighten with the
two-pin spanner.
1 609 929 S69 | (20.4.09)
English | 27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pws 20-230 jPws 1900

Tabla de contenido