Care And Storage; In The Event Of Problems - Beurer MG 250 Instrucciones Para El Uso

8. Care and storage

CLEANING
WARNING
• Before cleaning disconnect the power supply unit from the mains socket and disconnect it from
the device.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
CAUTION
• If you use the transport lock screws, take care to remove these before starting the device when you
next use it.

9. In the event of problems

Problem
Massage heads
rotating at
reduced speed.
Massage heads
only rotate in the
upper or lower
region.
Massage heads
not moving.
Cause
The load on the massage
heads is too great.
The massage has been
activated for the limited
region.
Appliance not connected to
the power supply.
Device not switched on.
Transport locks were not re-
moved. Massage mechanism
is damaged.
Overheating protection
tripped, device is damaged.
Remedy
Reduce the contact pressure on the head.
Press the FULL BACK, UPPER BACK or LOWER
BACK buttons to change the massage region.
Press the NECK button to activate the neck mas-
sage.
Connect the plug to the mains supply and switch
on the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the service ad-
dress.
Contact your authorized dealer or the service ad-
dress.
14
.