Care And Storage; In The Event Of Problems; Disposal - Beurer MG 295 HD-3D Manual De Instrucciones

• If the device is stopped by pressing a massage area button twice, it also returns to the starting position
after 15 minutes and then switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off first and wait
until it has returned to the initial position.
Note
• The device has an automatic shut-off mechanism set to a maximum operating period of 15 minutes.

10. Care and storage

Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable neck cover can be machine washed at 40ºC. Please note the symbols for care and
cleaning on the label sewn into the cover.
The PU cover at the back is secured with a hook-and-loop fastener under the material bearing the
beurer logo and can be removed from there.
The cover in the neck area can be removed with the zip fastener.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
Ensure that you use a stable clothes hanger made from wood that is able to carry the weight of the device.

11. In the event of problems

Problem
Massage heads
are moving slowly.
Massage heads are
moving in the upper
or lower area only.
Massage heads
not moving.

12. Disposal

CAUTION
For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
Cause
The load on the massage
heads is too great.
The massage has been acti-
vated for the limited region.
Appliance not connected to
the power supply.
Device not switched on.
Overheating protection
tripped, device is damaged.
Remedy
Reduce the contact pressure on the head.
Press the full back, upper back, lower back buttons
to change the massage region.
Press the neck button to activate the neck massage.
Connect the plug to the mains supply and switch on
the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the service ad-
dress.
17
.