Tabla de contenido
Publicidad
Step 2
Separate the EXTENSION SLIDES (II) from the
å
EXTENSION RAILS (HH) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (HH) to the SMALL RIGHT
å
END (C2) and SMALL UPRIGHT (E2). Use four GOLD
5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
Finished edge
Page 8
II
Push the black lever in and pull the SLIDE from the RAIL.
E2
Open end
C2
HH
422002
Remember:
Righty tighty.
Lefty loosey.
HH
Finished edge
HH
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Open end
Publicidad
Tabla de contenido
