Using Subwoofer Output; Adjusting Subwoofer Settings; Using The High Pass Filter - Pioneer FH-P4100R Manual De Operación

Section
10
Digital Signal Processor

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Switching the rear output setting
on page 46.
1 Press DSP to select SUB.W.
When the rear output setting is subwoofer,
you can select SUB.W. Press DSP until SUB.W
appears in the display.
2 Press a to turn subwoofer output
on.
SUB.W :ON appears in the display. Subwoofer
output is now on.
# You can turn off subwoofer output by press-
ing b.
3 Press c or d to select the phase of
subwoofer output.
Press c to select reverse phase and
pears in the display. Press d to select normal
phase and appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press DSP to select the subwoofer
setting.
When the subwoofer output is on, you can se-
lect the subwoofer setting. Press DSP until
80Hz appears in the display.
# If the subwoofer setting has been previously
adjusted, the frequency of that previously se-
lected will be displayed, such as 50Hz or 125Hz.
44
En
44 CRD3576-A
All manuals and user guides at all-guides.com
ap-
Black plate (44,1)
2 Press c or d to select cut-off
frequency.
Press c and 50Hz is displayed. Press d and
125Hz is displayed. Only frequencies lower
than those in the selected range are output
from the subwoofer.
3 Press a or b to adjust the output
level of the subwoofer.
Each press of a or b increases or decreases
the level of the subwoofer (e.g., +6 to 15).
Press a or b until you see the desired value
displayed.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front speakers, switch the HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from
the front speakers.
1 Press DSP to select HPF.
When the rear output setting is subwoofer,
you can select HPF. Press DSP until HPF ap-
pears in the display.
2 Press a to turn high pass filter on.
HPF 80Hz appears in the display. High pass fil-
ter is now on.
# To turn high pass filter off, press b.
3 Press c or d to select a high pass
filter range.
Press c and HPF 50Hz is displayed. Press d
and HPF 125Hz is displayed. Only frequencies
higher than those in the selected range are
output from the front speakers.