Adjusting Subwoofer Settings; Adjusting Source Levels - Pioneer DEH-P4400R Manual Del Usuario

Audio Adjustments

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press to select the subwoofer set-
AUDIO
ting.
When the subwoofer output is on, you can
select the subwoofer setting. Press
appears in the display.
80Hz
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
.
125Hz
2 Press 2 or 3 to select cut-off frequency.
Press 2 and is displayed. Press 3 and
50Hz
is displayed. Only frequencies lower than
125Hz
those in the selected range are output from the
subwoofer.
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
Press 5 or ∞ until you see the desired value
displayed.

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
until
AUDIO
1 Compare the FM tuner volume level with
the level of the source you wish to adjust (e.g.,
built-in CD player).
or
50Hz
2 Press
Press
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
•
volume is increased or decreased.
• Since the FM tuner volume is the control, it is
to ).
+6 –6
• The MW/LW tuner volume level can also be
• The built-in CD and the multi-CD players are
to select
AUDIO
until appears in the display.
AUDIO SLA
– is displayed as the source
SLA :+4 SLA :–4
Notes
not possible to apply source level adjustments
to the FM tuner.
adjusted with source level adjustments.
both set to the same source level adjustment
volume automatically.
Section
.
SLA
En
07
35