Metabo HPT C 18DSL Manual De Instrucciones página 15

2. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 10)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The Table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
Remaining battery
indicator lamp
Remaining battery
indicator switch
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
3. Working performance per single charge (Reference
data)
○ Cutting capability diff ers according to the condition
of lumber, type of saw blade, ambient temperature,
battery characteristics, etc.
Fig. 10
Table 5
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
Wood
2 × 8 (Spruce-Pine-Fir)
Concreteform plywood
(1/2" (12 mm) t)
To improve working effi ciency per single charge,
○ Minimize operation (no-load operation) other than
cutting;
○ Avoid any unreasonably forced pressure to the motor
during cutting operation by twisting or pressing the
circular saw forcibly;
○ Avoid any use of dull saw blade.
4. Cutting procedures
CAUTION
● Recheck that the saw blade is securely clamped.
● Confi rm that the wing-nut for adjusting the slot
depth, the wing-bolt for adjusting the angle of
inclination.
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch at
the front of the base (Fig. 11).
(2) When the base is not inclined, use the large notch
(Fig. 11, Fig. 12).
If the base is inclined (45 degrees), use the small
notch (Fig. 11, Fig. 13).
Not inclined
Saw blade
Fig. 11 <Top View>
English
Capacity
75 cuts
133 ft (40 m)
15