ZUMEX Speed Serie Manual De Usuario página 26

Tank/Cooler Buoy (52)
Tank Model
a) If the support with buoy is loose, loosen the knobs on the support (Fig. 16 (1)).
b) Line up the lugs on the support with the inside of the lid (Fig. 16 (2)).
c) Tighten the knobs (Fig. 16 (2 and 3U)).
d) If a deep clean is necessary, remove the reverse the order of the previous steps and
remove the shaft (Fig. 16 (4)).
Cooler or Tank model
Slacken the upper lugs. Line up the plate with the openings from below. Tighten the upper
lugs again (Fig. 18).
Tank (53)
Use the thread to secure the Self Service tap to the Tank container (Fig. 5+).
Tank Tap (55)
Use the thread to secure the Self Service Tap to the Tank container. Make sure that it is in
upright position (Fig. 17.1).
The Tank Tap can work continuously or discontinuously. Just turn the handle 180º and it will be
locked when the handle is lowered, thus permitting free spout.
For cleaning, you can remove the upper part of the Self Service Tap (Fig. 17.2).
Level detector (56)
This component only needs to be manipulated if a spare part is requested. Remember to place
the detector in the same position as the original detector. If you have a Tank machine, the
detector is located in the upper part; if you have a Cooler machine, it is located in the lower
part (Fig. 5+ y 6).
Cooler unit (70)
Place the cooler unit in its housing in the stand (Fig. 6).
Mount the components as indicated in Fig. 18 in this order.
a) Mount the piston-gasket and the lever in the tank following the steps indicated in the
enclosed drawing.
b) Fit the tank.
c) Adjust the pump lid inside the tank with the arrow pointing towards you.
d) Secure the metal coupler plate, securing the tank with it.
Podium Tank S All-in-One (90), Podium Black All-in-One (90+),
+plus
Podium Mirror All-in-One (90+), Podium Cooler (100)
Machine placement on display stand:
Important! This operation must be carried out by 2 or 3 people. It must never be attempted
!
by just one person.
Lock the front wheels of the stand with the brake pedal to prevent it from moving during
the installation.
After unpacking the stand, remove the screws from the fixing brackets and put them on
one side for later. See detail "A" of Fig. 8.
The peel chutes and the drip tray of the stand with filter are located on the inside of the
stand.
Place the machine on the stand, making the inside corners of the machine base coincide
with the two rubber blocks of the stand. Thus, the fixing bracket holes will coincide with
the machine holes. You can now secure the machine with the screws mentioned above
(See Fig. 5+ y 6).
Remember:
The machine and display stand are joined together with the screws supplied, as indicated
in this instructions manual.
Never try to tilt the machine or the stand. To move, unlock the wheels.
Individual features for Podium Tank S
+plus
For the Tank stand, secure the drip tray with its filter in the display stand.
Component 90.7 varies depending on the stand model purchased:
Self Service stand: Component SS stand filter (90.7A).
Tank stand: Component TANK tank guides (90.7B).
All-in-One (90)
EN
49