Publicidad
Idiomas disponibles
Idiomas disponibles
Using Your Radio
Operation
Turning On Your microTALK
On/Off Power
To Turn On Your Radio:
1. Rotate the On/Off Volume knob clockwise
to turn On your radio and adjust the volume.
A series of tones will indicate the radio is On.
Your microTALK
ready to receive transmissions. The radio is
always in Standby Mode, except when the
Talk, Call or Mode buttons are pressed.
Battery Low
Battery Low
Your microTALK
that shows when battery power is decreasing.
The greater the number of ascending bars visible,
the stronger the battery level. When the battery
level is low, the last bar and "bALo" will flash
indicating your batteries should be replaced
or recharged, if using rechargeable batteries.
Auto Battery Save
Battery Save Mode
Your microTALK
designed to extend battery life. If there are
no transmissions within ten (10) seconds,
the radio will automatically switch to Battery
Save Mode and Power Saver icon will flash
in the display. This will not affect the radio's
ability to receive incoming transmissions.
Communicating with Another Person
Talk Button
To Talk To Another Person:
1. Press and hold the Talk button.
2. With the microphone about two (2)
inches (5 cm) from your mouth,
2 inches (5 cm)
speak in a normal voice.
From Mouth
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to
the same channel to communicate.
English
6
®
Radio
®
radio is now in Standby Mode,
®
radio has a battery level meter
®
radio has a unique circuit
Introduction
Mode Button
•
•
Channel Button
•
Channel Number
•
Operation
Customer Assistance
Scrolling Through
the Mode Function
By scrolling through the Mode function, you will
be able to select or turn On preferred features of
your microTALK
®
radio. When scrolling through
the Mode function, your radio features will be
displayed in the same predetermined order:
Set Privacy Codes
Set VOX On/Off
Set VOX Sensitivity Level
Set Channel Scan
Set Privacy Code Scan
Set VibrAlert
®
and/or Call Alert
Set Call Tones
Set "Roger Beep" On/Off
Set Keystroke Tones On/Off
Channels
To Select a Channel:
1. With the radio On, select any of the
22 channels by pressing the Channel Up
or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared with FRS/
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 17 for FRS/GMRS frequency
allocations and compatibility charts.
Nothing comes close to a Cobra
Warranty
•
•
™
7
Publicidad
