Troubleshooting - Kenwood KMM-BT312U Manual De Instrucciones

MORE INFORMATION
About Pandora
• Pandora is available only in the U.S., Australia and New Zealand.
• Because Pandora is a third-party service, the specifications are
subject to change without prior notice. Accordingly, compatibility
may be impaired, or some or all of the services may become
unavailable.
• Some functions of Pandora cannot be operated from this unit.
• For issues using the application, please contact Pandora at pandora-
support@pandora.com.
About iHeartRadio
• iHeartRadio® is a third-party service, therefore the specifications are
subject to change without prior notice. Accordingly, compatibility
may be impaired or some or all of the services may become
unavailable.
• Some iHeartRadio® functionality cannot be operated from this unit.
About Bluetooth
• Depending on the Bluetooth version of the device, some Bluetooth
devices may not be able to connect to this unit.
• This unit may not work with some Bluetooth devices.
• Signal conditions vary, depending on the surroundings.
• For more information about Bluetooth, visit the following website:
www.kenwood.com/cs/ce/
22

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING THEN PWR
ON" appears.
"PROTECTING SEND SERVICE" appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the display is
incorrect.
The unit does not work at all.
(For )
"SET ERROR" / "DEL ERROR"
• Radio reception is poor.
• Static noise while listening to the
radio.
"READING" keeps flashing.
Elapsed playing time is not correct.
Correct characters are not displayed
(e.g. album name).
"NA FILE"
"READ ERROR"
"NO DEVICE"
"COPY PRO"
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of the
speaker wires are insulated properly. Turn the power on again.
Send the unit to the nearest service center.
Clean the connectors. ( 2)
Reset the unit. ( 3)
Setting/deleting the remote control ID is unsuccessful. Turn the
power off, then turn on the power and perform the operation
again. ( 5)
• Connect the antenna firmly.
• Pull the antenna out all the way.
Do not use too many hierarchical levels or folders.
This is caused by how the files are recorded.
This unit can only display uppercase letters, numbers, and a limited
number of symbols.
Make sure the media contains supported audio files. ( 21)
Copy the files and folders onto the USB device again. If this does not
solve the problem, reset the USB device or use another USB device.
Connect a USB device, and change the source to USB again.
A copy-protected file is played.