Specifications - Kenwood KMM-BT312U Manual De Instrucciones

TROUBLESHOOTING
Symptom Remedy
"DEVICE FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. ( 18,
DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is
used.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"NO INFO" Bluetooth device cannot get the contact information.
"HF ERROR XX" / Reset the unit and try the operation again. If this does not
"BT ERROR" solve the problem, consult your nearest service center.

SPECIFICATIONS

FM Frequency Range
Usable Sensitivity (S/N = 26 dB)
Quieting Sensitivity (DIN S/N = 46 dB)
Frequency Response (±3 dB)
Signal-to-Noise Ratio (MONO)
Stereo Separation (1 kHz)
AM Frequency Range
Usable Sensitivity (S/N = 20 dB)
USB Standard
File System
Maximum Supply Current
Frequency Response (±1 dB)
Signal-to-Noise Ratio (1 kHz)
Dynamic Range
Channel Separation
MP3 Decode
WMA Decode
AAC Decode
WAV Decode
FLAC Decode
Frequency Response (±3 dB)
Input Maximum Voltage
Input Impedance
87.9 MHz — 107.9 MHz (200 kHz space)
8.2 dBf (0.71 μV/75 Ω)
17.2 dBf (2.0 μV/75 Ω)
30 Hz — 15 kHz
64 dB
40 dB
530 kHz — 1 700 kHz (10 kHz space)
29 dBμ (28.2 μV)
USB 1.1, USB 2.0 (Full speed)
FAT12/ 16/ 32
DC 5 V 1 A
20 Hz — 20 kHz
105 dB
90 dB
85 dB
Compliant with MPEG-1/2 Audio Layer-3
Compliant with Windows Media Audio
AAC-LC ".m4a" files
RIFF waveform Audio Format
(Linear PCM only)
FLAC files
20 Hz — 20 kHz
1 000 mV
30 kΩ
25
ENGLISH