Metra 95-8210 Instrucciones De Instalación página 3

Kit Assembly
Double DIN radio provision
1. Snap the double DIN brackets to
the outside edge of the double DIN
trim plate. (Figure A)
2. Temporarily rest the factory
brackets onto the sides of the
radio. These brackets will be
permanently attached to the radio
after following the next step.
(Figure B)
3. Slide the double DIN radio into the
bracket/trim plate assembly and
secure the radio to the assembly
using the screws supplied with the
radio. (Figure C)
4. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
(Figure A)
(Figure B)
(Figure C)
95-8210
3
Notes