Sears Kenmore Elite 106.5177 Serie Manual De Uso Y Cuidado página 20

5. To dispense water, press a sturdy glass against the dispenser pad OR
place the glass below the dispenser opening and press either the
DISPENSE WATER button or the ACCENT LIGHT button. Hold the
glass close to the water dispenser spout to ensure that the water
dispenses into the glass.
A. Water dispenser spout
NOTE: While dispensing water, the digital display will count down
how much water remains to be dispensed, according to the volume
you selected. The flow of water will automatically stop once the
desired volume has been dispensed.
6. To stop dispensing before the selected volume has been dispensed,
remove the glass from the dispenser pad OR press either the
DISPENSE WATER button or the ACCENT LIGHT button a second
time.
NOTE: If you stop dispensing before the desired volume has been
dispensed, the digital display will continue to show how much water
remains to be dispensed. The display will turn off after 1 minute of
inactivity.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when the
dispenser pad is pressed. To turn off the ice maker, see "Ice Maker and
Storage Bin."
Your ice maker can produce both crushed and cubed ice. Before dispensing
ice, select which type of ice you prefer by pressing the WATER/ICE button.
The display screen indicates which type of ice is selected.
CRUSHED
For crushed ice, cubes are crushed before being dispensed. This may cause
a slight delay when dispensing crushed ice. Noise from the ice crusher is
normal, and pieces of ice may vary in size. When changing from crushed
to cubed, a few ounces of crushed ice will be dispensed along with the first
cubes.
20
A
CUBED
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch between cubed
and crushed, press WATER/ICE.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser pad. Hold the glass close to
the ice guide to ensure that the ice dispenses into the glass.
IMPORTANT: You do not need to apply a lot of pressure to the pad in
order to activate the ice dispenser. Pressing hard will not make the ice
dispense faster or in greater quantities.
NOTE: To dispense both water and ice at the same time, press the
DISPENSE WATER button while using the dispenser pad to dispense
ice.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the pad. The dispenser may continue to make
noise for a few seconds after dispensing.
A. Ice guide
A