Homelite UT43100 Manual Del Operador página 23

 Lay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.
 Place the chain drive links into the bar groove as
shown.
NOTE: Make certain of direction of chain.
 Position the chain so there is a loop at the back
of the bar.
 Hold the chain in position on the bar and place
the loop around the sprocket.
 Fit the bar flush against the mounting surface
so that the bar studs are in the long slot of the
bar.
NOTE: When placing the bar on the bar studs,
ensure that the adjusting pin is in the chain ten-
sion pin hole.
 Replace the chain cover.
 Replace the sleeve and chain cover lock knob;
rotate knob clockwise to tighten. The bar should
still be free to move for tension adjustment.
 Remove all slack from the chain by turning the
chain tensioning knob clockwise until the chain
seats snugly against the bar with the drive links
in the bar groove.
 Lift the tip of the guide bar up to check for
sag.
 Release the tip of the guide bar and turn the
chain tensioning knob 1/2 turn clockwise.
Repeat this process until sag does not exist.
 Hold the tip of the guide bar up and tighten the
chain cover lock knob.
The chain is correctly tensioned when there is no
sag on the underside of the guide bar, the chain
is snug, but it can be turned by hand without
binding.
NOTE: If chain is too tight, it will not rotate. Loosen
the chain cover lock knob slightly and turn the
chain tensioning knob 1/4 turn counterclockwise.
Lift the tip of the guide bar up and retighten the
chain cover lock knob. Ensure that the chain will
rotate without binding.
MAINTENANCE
ADJUSTING THE CHAIN TENSION
See Figures 34 - 35.
Never touch or adjust the chain while the motor
is running. The saw chain is very sharp. Always
wear protective gloves when performing main-
tenance on the chain.
 Stop the motor and disconnect from power
supply before setting the chain tension.
Page 23 — English
FlatS on drive linkS
≈
.050 in.
WARNING:
Fig. 32
Fig. 33
Fig. 34
Fig. 35