Temperature Regulation - Whirlpool ADN350S Manual De Instrucciones

For AND350S, see Page 1. Fig. 1
For AND480S, see Page 2, Fig. 4
1 Lighting switch
2 Thermostat knob
3 Thermostat position indicator
Electricity supply indicator. When the
4 appliance is connected to the electricity
supply, the green indicator light is illuminated.
5 Interior light (LED)
6 Blower*
*Opening the door the blower switches off.
The temperature in the device compartment is controlled using the thermostat knob 2 (see fig.
1 and fig. 4) by turning it to one side or the other.
Thermostat is switched off when in position 0: the compressor is switched off – electric current is not
switched off. Turning thermostat to any position (except 0) turns on the blower.
The temperature indication in digits is shown beside the thermostat knob. For model ADN350S:
when the door is closed, the temperature setting can be seen on the thermostat position
indicator display 3 (see fig. 1, page 1).
ATTENTION! The numbers "0, 1, 2, 3, 4, 5" do not mean a specific temperatures.
The temperature is regulated on the scale of five digits.
0 = Compressor is switched off WARNING! Electric current is not switched off.
1 = highest temperature (lowest cooling)
5 = lowest temperature (highest cooling)
THE TEMPERATURE IN THE DEVICE COMPARTMENT MAY VARY DEPENDING ON
AMBIENT TEMPERATURE, THE AMOUNT OF FOODSTUFFS, THE TEMPERATURE OF THE
FOODSTUFFS, AND HOW OFTEN THE APPLIANCE DOORS ARE OPENED AND CLOSED.
If the room is cool, the appliance cools less. The temperature in the appliance may
therefore rise. Use the thermostat wheel to set a lower temperature.
To avoid food contamination, follow the instructions below:
Prolonged opening of the door can significantly increase the temperature in the compartments
•
of the appliance: only open the door for the time required to place / remove food.
Regularly clean surfaces that may come into contact with food and accessible drainage
•
systems.
Store fresh meat and fish in suitable containers in the refrigerator so that they do not come
•
into contact with or drip on other food.
Do not put unpackaged food in the refrigerator.
•
If the appliance is left empty for a long time, switch it off, defrost, clean, dry and leave the
•
door open to prevent mold from forming inside the appliance.
Strictly adhere to the expiration date for foods as stated by the manufacturer on the product
•
packaging
THE APPLIANCE BASIC PARTS

TEMPERATURE REGULATION

7 Shelves
8 Thaw water channel cleaner
9 Condenser
10 Compressor
11 Supply cord
12 Thaw water drip tray
13 Blower switch
8