Hydraulics; Prearrangements For Optionals; Operation; Putting Into Operation - Whirlpool ACO 023 Uso E Manutenzione

In order to safeguard the electric plant of the refrigerator from any overloads or short circuits, install a
magnetothermic switch at the head of the socket with adequate interruption power
(See Plaque D).

6. 4. 2 HYDRAULICS

If the model does not include a condenser unit, it is necessary to connect it to a drainage system for the
discharge of water from defrosting using a suitable tube of appropriate dimensions.

6. 4. 3 PREARRANGEMENTS FOR OPTIONALS

Locks: all the upright refrigerators are predisposed for the installation of locks, even those models which do not
include them. For assembly see Fig.5.
7.

OPERATION

7. 1 PERSONNEL
The staff who are to use and install the appliance, must possess (or acquire through adequate formation and
training) the following skills and must understand the contents of this manual and all the relevant Safety
Information:
• General technical knowledge enough o understand the contents of the Manual.
• Awareness of the main hygiene, accident prevention and technological regulations.
7. 2

PUTTING INTO OPERATION

If the equipment has been mistakenly positioned horizontally during transport, wait about 2 hours, after putting
it into a vertical position, before putting it into operation.
7.3

TIMERS

See enclosed Manual for Instructions and Use 13.2.1.2
7. 4

TEMPERATURE REGULATION

The choice of temperature must take into consideration:
• The type of product which is going to be kept in the cold storage room (see attached 13.2.5);
• The temperature of the environment;
• The frequency of opening.
Fig. 5
26