Scanning The Tracks; Intro Scan - Sony CDX-C780R Manual De Instrucciones

You can label CD and CD TEXT discs with a
personalized name using the disc memo
function, refer to "Labeling a CD" (page 29).
However, if you use personalized labels, they
will always take priority over the original CD
TEXT information when such information is
displayed.
Tips
• If the name of the MD or CD TEXT disc is too
long, you can scroll it across the display by
pressing (SHIFT), then (2) (N).
• If you want to display the original CD TEXT
information after labelling the CD TEXT disc with
a personalized name, press (SHIFT) , then (5)
(n).
Automatically scrolling a disc name
— Auto Scroll
If the disc name/artist name or track name on
a CD TEXT disc or MD exceeds 10 characters
and the Auto Scroll function is on,
automatically scrolls on the display as follows:
• The disc name appears when the disc has
changed (if the disc name is selected).
• The track name appears when the track has
changed (if the track name is selected).
If you press (DSPL) to change the display
item, the disc or track name of the MD or CD
TEXT disc is scrolled automatically whether
you set the function on or off.
1
During playback, press (SHIFT).
2
Press (3) (SET UP) repeatedly until
"A.Scrl" appears.
3
Press (5) (n) to select "A.Scrl on."
4
Press (SHIFT)
To cancel Auto Scroll, select "A.Scrl off" in
step 2 above.
Note
For some CD TEXT discs with extremely many
characters, the following cases may happen:
— Some of the characters are not displayed.
— Auto Scroll does not work.
Locating a specific track
— Automatic Music Sensor (AMS)
During playback, push the SEEK/AMS
control up or down once for each track
you want to skip.
To locate succeeding
tracks
To locate preceding
tracks
Locating a specific point in a track
— Manual Search
During playback, push the SEEK/AMS
control up or down and hold.
Release when you have found the
desired point.
To search forward
To search backward
Locating a disc by disc number
— Direct Disc Selection
Press the number button that
corresponds with the desired disc
number.
The desired disc in the current unit begins
playback.

Scanning the tracks

— Intro Scan

You can play the first 10 seconds of all the
tracks on the current disc.
1
During playback, press (SHIFT), then
press (4) (PLAY MODE) repeatedly until
"Intro" appears.
2
Press (5) (n) to select "Intro on."
Intro Scan starts.
3
Press (SHIFT).
To go back to normal playback mode, select
"Intro off" in step 2 above.
EN
25