Cd Player Cd/Md Unit (Optional); Playing A Disc - Sony CDX-F5500 Manual De Instrucciones

CD Player
CD/MD Unit (optional)
In addition to playing a CD with this unit, you
can also control external CD/MD units.

Playing a disc

(With this unit)
1
Press (OPEN) and insert the disc
(labelled side up).
2
Close the front panel.
Playback starts automatically.
If a disc is already inserted, press (SOURCE)
repeatedly until "CD" appears to start playback.
To Press
(OFF)
Stop playback
(OPEN) then Z
Eject the disc
(SEEK) (–/+)
Skip tracks
– Automatic (./>)
Music Sensor [once for each track]
(SEEK) (–/+)
Fast-forward/
reverse (m/M)
– Manual Search [hold to desired point]
(1)(ALBUM–) or
Skip albums*
(2)(ALBUM+)
– Albums selection
* Available only when an MP3 file is played.
To skip tracks continuously, press (SEEK) (+) or
(SEEK) (–), then press again within 2 seconds
and hold.
Notes
• Before playing a track, this unit reads all track and
album information on the disc. Depending on the
track structure, it may take more than a minute
before playback begins. During this time, "READ" is
displayed. Play will automatically start when reading
is complete.
• Depending on the condition of the disc, it may not
play back (page 6, 7).
• While the first/last track on the disc is playing, if
(SEEK) (+) or (SEEK) (–) is pressed, playback skips
to the last/first track of the disc.
• When the last track on the disc is over, playback
restarts from the first track of the disc.
• If you play a high-bit rate MP3 file such as 320 kbps,
sound may be intermittent.
(With optional unit)
1
Press (SOURCE) repeatedly to select
"CD" or "MD (MS*
2
Press (MODE) repeatedly until the
desired unit appears.
Playback starts.
To Press
(1)(DISC–) or
Skip discs
(2)(DISC+)
– Disc selection
[once for each disc]
(1)(ALBUM–) or
Skip albums* 2
(2)(ALBUM+)
– Albums selection
[hold to desired album]
*1 MS: MG Memory Stick System-up Player MGS-X1
*2 Available only when an MP3 file is played.
Cautions when connecting MGS-X1 and MD unit(s)
This unit recognizes MGS-X1 as an MD unit.
• When you want to play MGS-X1, press (SOURCE) to
select "MS" or "MD." When "MS" appears in the
source display, MGS-X1 starts to play. When "MD"
appears in the source display, press (MODE) to
select "MS," to start playback.
• When you want to play an MD unit, press (SOURCE)
to select "MD" or "MS." If your desired MD unit
appears in the source display, it starts to play. If "MS"
or another MD unit appears in the source display,
press (MODE) to select your desired MD unit, to
start playback.
Notes when playing back a disc with non-audio CD
data/MP3 file
If a disc with no MP3 files is inserted:
– in the case of this unit, "NO MUSIC" appears in the
display, and the display becomes the clock display
(CD playback stops).
– in the case of an optional MP3 compatible CD unit,
"NO MUSIC" appears in the display and playback of
the next disc starts.
– in the case of an optional CD unit, which is
incompatible with MP3, the disc will play back with
no sound.
Note
With optional unit connected, playback of the same
source will continue on to the optional CD/MD unit.
1 )."
11