Cembre PNB-4KE Manual De Uso Y Mantenimiento página 4

ENGLISH
4. INSTRUCTION FOR USE
4.1) Setting
(Ref. to Fig. 2)
The press is free standing and supplied
ready to use by connecting the pneumatic
coupler (25) on the manual control (30) to
an air supply at 6 bar pressure.
4.2) Operation
For a complete cycle, (compression and
release) briefly press the control: do
not keep the control depressed other-
wise the press may continue to cycle.
To perform a crimping operation:
– Fit the cable into the end sleeve.
– Insert the cable and the end sleeve
through the appropriate aperture in
the guard until positively located on
the the lower die (Ref. to Fig. 1).
– Operate the press using the control (30).
– Release the control.
– Remove the crimped joint.
5. MAINTENANCE
All maintenance operations must be carried out with the press disconnected from the air supply
by detaching the connection (25).
The press is robust and does not require special attention; to maintain the correct operation, pro-
ceed as follows:
5.1) Accurate cleaning
After use clean the press with a clean cloth, to remove dust and dirt particles.
Periodically, open the rear casing (22) by removing the fixing screws (20 and 26).
Use a pneumatic blowgun to remove residuals from the mechanism, dies and guards.
Periodically the compression area must be cleaned as follows:
– Remove the two screws (15) and remove the front protection (13).
– Remove the screw (08) which holds the die block and slide it out from the front.
– Slide out the top die making sure not to lose the spring and, using a clean cloth remove any dirt
which may be present.
– Replace the spring, place the top die and the protection in their original positions and tighten
the relative locking screws (08 and 15).
(Ref. to Fig. 2)
Die
jaw
0.3
PKE308
PKD506
0.5
PKD508 PKE508
PKD510
PKD7506
PKD7508 PKE7508
0.75
PKD7510
PKD7512
PKD106
PKD108 PKE108
1.0
PKD110
PKD112
PKD1508 PKE1508
PKD1510 PKE1510
1.5
PKD1512
PKD1518 PKE1518
PKD2508 PKE2508
2.5
PKD2512 PKE2512
PKD2518 PKE2518
PKD410 PKE410
4
PKD412 PKE412
PKD418 PKE418
6
PKD612 PKE612
PKD618 PKE618
PKD1012 PKE1012
10
PKD1018 PKE1018
End sleeves types
PKC306
PKC308
PKC508
PKC510
PKC7508
PKC7512
PKT508
PKC108 PKT510
PKC112
PKC1508 PKT7508
PKC1510 PKT7510
PKC1518
PKC2508 PKT108
PKT110
PKC2512 PKT1508
PKC2518 PKT1512
PKC410 PKT2510
PKC412 PKT2512
PKC418
PKT412
PKC612
PKC618
PKC1012 PKT614
PKC1018
4
KE506ST
KE508ST
KE7506ST
KE7508ST
KE106ST
KE110ST
KE1508ST
KE1510ST
KE2508ST
KE2510ST
KE410ST
KE412ST
KE610ST
KE612ST
KE616ST
KE1016ST
Table 1