OHAUS Pioneer PX Serie Manual De Instrucciones página 29

PX Series Balance
Continue to follow the instructions on the display until the calibration is completed.
Steps for linearity calibration
1. Press and hold the Tare / Menu-Cal button, and the
Calibration Menu will display.
2. Press Yes to enter the Calibration Menu. To change the
calibration mode, press No until Linearity Cal (linearity
calibration) is displayed.
3. Press Yes to begin the linearity calibration.
4. Calibration masses value will be shown in the screen.
After the display shows "Place weights" and "50.0000 g",
place weight(s) of 50 g on the pan for calibration.
5. Remove the weight(s) of 50 g from the pan. After a while,
"100.0000 g" will be displayed on the screen. Please
place weight(s) of 100 g on the pan for calibration.
EN-27