Dynamic Weighing - OHAUS Pioneer PX Serie Manual De Instrucciones

PX Series Balance
6. Remove the reference sample and place the test
object on the pan. The ratio of the test object to the
reference sample
percentage.
7. To view the reference sample weight or the test
object weight, press the Function / Mode button.
Item Settings
Note:
If the previously established reference sample weight needs to
be kept, press No when the message "Clear reference?"
displays.
Printing Setup:
Changing printing setup. See Section 7 for more information.
4.4

Dynamic Weighing

Note: Before using any application, be sure the balance has been leveled and calibrated. Clear the pan before
beginning a new Dynamic Weighing cycle.
Use this application to weigh an unstable load, such as a moving animal.
Dynamic Weighing
1. Press and hold the Function / Mode button until
Dynamic Weighing appears.
2. After confirmation by pressing Yes, the message
"Change parameter?" will appear on the screen.
3. Press Yes, and then the message "Average time 10
s" will display with the numeral "10" flashing. Press
No or Back to increase or decrease the value as
desired.
weight is displayed as a
EN-11