Pipe Adapter - Textron Greenlee Ultra Tugger 15000-22 Manual De Instrucciones

Setup

Pipe Adapter

Requires: Exposed metallic pull conduit of least
63.5 mm (2-1/2") diameter.
Do not mount the pipe adapter to the
following:
• steel conduit less than 65 mm
(2-1/2") in diameter
• PVC conduit of any size
These conduits will not support the
loads imposed by the puller.
Failure to observe this warning can
result in severe injury or death.
NO
When setting up the pipe adapter,
do not use the vise chains on a
structural support that is less than
51 mm (2") or more than 254 mm
(10") wide. An oversized or under-
NO
sized structural support can allow
the puller to slide or break loose
and strike operator.
Failure to observe this warning can
result in severe injury or death.
Greenlee / A Textron Company
®
Ultra Tugger Cable Puller and Pulling Packages
1. Remove the sheave from the frame.
2. Position the frame against the conduit.
29
Sheave
Sheave Shaft
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Hitch Pin Clip
Frame