T-Stand - Textron Greenlee Ultra Tugger 15000-22 Manual De Instrucciones

Setup (cont'd)

T-Stand

Requires: Adequate clearance. See "Typical Setups
Illustrated."
1. Set the puller on the floor with the mounting holes
upward.
2. Position the boom mount so that the puller gearbox
will fit into the cradle of the boom mount and the
puller mounting plates straddle the boom mount
plates.
Gearbox
Boom Mount
Plates
3. Mount the boom mount to the puller.
4. Install two pins from the motor side. Secure the pins
with two hitch pin clips.
Install Hitch Pins
from Motor Side
Greenlee / A Textron Company
Ultra Tugger
Puller
Cradle
Mounting
Plates
Boom Mount
Install Hitch Pin Clips
on Capstan Side
®
Cable Puller and Pulling Packages
5. Align the two sets of holes in the T-stand with the
two sets of holes in the boom mount.
6. Install two pins. Secure the pins with hitch pin clips.
T-Stand
7. Continue with Setup: Mounting Components later in
this manual.
32
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Insert
Pins Here