Westinghouse Leon Manual Del Usuario página 20

21
How to operate your ceiling fan
Restore electrical power to the outlet box by turning the electricity on at the main fuse box. To make the
fan operational, install 2 AAA 1.5V battery by removing battery cover on back of transmitter, installing
battery, and replacing battery cover.
1. Adopt RF wireless digit emission technique, biunique controlled, coincident code rate is less than one
millionth.
2. Receiver can be controlled by any angles of the transmitter in prescriptive space, unrestricted by
direction with the memory function, the controller can save the status (light and direction) while the
supply power OFF and resume to the original after re-load the power supply.
3. The transmitter and receiver are matched at the factory. Please follow the point 5 for re-match when
the match is failed.
4. Matching process can be done by fan without the blades, the same transmitter can control another
identical model ceiling fan.
5. Learning code matching mode is used between transmitter and receiver. Turn'ON'the supply power
within 30 seconds and press the transmitter's fan switch button ' 'for 5 seconds, it can load normally
after hearing a long sound 'bee' , which means learning successfully and it can works normally.
6. Learning mode is not accepted after turn 'ON' the supply power for 30 seconds.
7. When the transmitter can't control the receiver, please check the battery switch touching normally or
not, correction of the positive and negative, full or empty of the power.
8. When the transmitter can't control the receiver, please check if any similar remote control is controlling
the products nearly, then check whether they are working, because remote controlled product with the
same frequency will disturb each other.
9. Low voltage of battery will affect the sensitivity of the transmitter and the signal reception accordingly,
(the indicated light will flash out its warning when the battery with the low voltage), must replace if
the battery is getting low voltage.
10. Please take out the battery from the transmitter when leaving unused for long time.
11. The maximum load of lighting will be 140W. Please connect the ground wire correctly, otherwise, it
may cause the light to strobe or flash.
12. When installing the fan, the fan ceiling cover don't press the antenna (or other wire), it is easy to
breakdown the wire and short-circuited.
20
ETL-ES-Leon-WH20