Card Remote Control Names Of Parts; Preparations; Replacing The Battery - Aiwa CDC-X504MP Manual De Instrucciones

CARD REMOTE CONTROL
Names of parts
1
DSPL
ALBUM
2
SOURCE
–
SEEK
3
ALBUM –
4
OFF
5
1 DSPL button
2 SOURCE button
3 SEEK (+/–) buttons
4 OFF button
5 VOL (+/–) buttons
6 MODE button
7 PRESET/ALBUM (+/–) buttons
8 ATT button
Note
If the display disappears by pressing (OFF) , it
cannot be operated with the remote control unless
(SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.

Preparations

A lithium battery is installed in the remote control
at the factory.
Before you use the remote control, be sure to
remove the insulating sheet by simply pulling it
out.
Remote control (back)
Insulating sheet
6
MODE
+
+
PRESET
7
+
SEEK
PRESET
–
8
+
ATT
VOL
–

Replacing the battery

1
Insert the tip of a pointed object A into the
hole B and pull out the battery holder to
remove the lithium battery (CR2025).
Remote control (back)
Battery holder
2
Install a new lithium battery (CR2025)* with
the 3 side facing up in the battery holder,
and push the battery holder into the unit
until it clicks.
* Use of any other battery may present a risk of
fire or explosion.
Note
When the infrared receptor on the main unit is
exposed to direct sunlight, it may not respond to
signals from the remote control.
Notes on lithium battery
• Keep the lithium battery out of the reach of
children. Should the battery be swallowed,
immediately consult a doctor.
• Wipe the battery with a dry cloth to assure a
good contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
A
B
11