Dmx Configuration - NEO PROTON 7 USB Manual De Usuario

Manual Color
This mode allows to combine the colors red, green and blue.
• Press the button MENU several times until the
display shows U-- , then press ENTER.
• Select the color r, g, b through the buttons
UP/DOWN. Then ENTER.
• Using UP/DOWN button, select the desired
color value 000 - 255.
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the
waiting time to exit the setup menu.
Dimmer
Enter in Dimmer mode to select specific dimming curve,
press the button MENU several times until shows dIM and
press ENTER to confirm.
• Press the button UP/DOWN to select OFF -
dIM1 - dIM2 - dIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the
waiting time to exit the setup menu.
P. 10
PROTON 7 USB
ENGLISH VERSION
Linking
Several Units may be interconnected in order to control all
further slave units to the same effect of the master unit. Use
standard DMX cables to daisy chain your units together via
the DMX connector on the rear of the units. For longer ca-
ble runs, we suggest a terminator at the last fixture.
• Connect the DMX OUT of the master unit via 3
pole XLR cable to the DMX IN of the first slave unit.
• Connect the DMX OUT of the first slave unit to
the DMX IN of the second slave unit, etc. until all
units are connected in a chain.

DMX Configuration

PROTON 7 USB is equipped with different DMX configuration.
• Press MENU to select the desired DMX configu-
ration (3ch-8ch).
• Press the button UP/DOWN to select the desid-
er value (001 - 512), then press ENTER to confirm.
• Press the MENU button to go back or to meet the
waiting time to exit the setup menu.