Operating The Charger - schulink SC1344 Manual Del Usuario

When the charger exits this mode, the battery will be at approximately 80%
recharged.
5. Absorption Mode – This mode finishes the charge of the battery by holding
the battery voltage constant until the current tapers off.
6. Monitoring Mode – The battery is allowed to rest for 24 hours before
checking for a loss of charge.
7. Float Mode – The charger is replacing energy the battery has lost through
self-discharge or idle draw of the attached vehicle.
8. Maintain – The charger checks the battery every 12 hours and puts the
charger into float mode to replenish lost energy from the battery.
RESETTING YOUR PASSWORD
1. In the log in screen, press Forgot Password. A password reset link will be
sent to the email address you provided during registration.
2. Enter your new password.
3. Reenter the new password.
4. Click Reset Password to complete the process.

14. OPERATING THE CHARGER

USING THE CHARGER WITHOUT THE INTERNET
The charger itself is a stand-alone device and will function as a battery charger/
maintainer without an internet connection. However, without an internet connection,
the App will not reflect the charging progress.
IMPORTANT: Do not start the vehicle with the charger connected to the AC outlet, or it
may damage the charger and your vehicle.
WARNING: This charger is equipped with an auto-start feature. Current is supplied
to the battery clamps before a battery is connected, and the clamps will spark if
touched together.
NOTE: This charger is also a maintainer, and can be left on the battery of vehicles
that are being stored.
USING THE QUICK-CONNECT CABLE CONNECTORS
Connect any of the three output cable assemblies to the charger in a matter of seconds.
IMPORTANT: Use the charger with only one connector at a time. Do not connect
accessory cables together. This will cause reverse polarity and damage the charger
and battery.
• 11 •