schulink SC1344 Manual Del Usuario página 14

CHARGE COMPLETION AND MAINTAIN MODE (Float Mode Monitoring)
Charge completion is indicated by the green LED pulsing and the digital display
scrolling "FULLY CHARGED AUTO MAINTAINING". This means that the charger
has stopped charging and has switched to the Maintain Mode of operation. NOTE:
If the charger has to provide its maximum maintain current (1.8A) for a continuous
12 hour period, it will go into Abort Mode (see Aborted Charge section). This is
usually caused by a load on the battery, or the battery could be bad. Make sure
there are no loads on the battery. If there are, remove them. If there are none, have
the battery checked or replaced.
MAINTAINING A BATTERY
This unit maintains both 6 and 12 volt batteries, keeping them at full charge. It
can charge small batteries and maintain both small and large batteries. If you
are maintaining a fully charged large battery, you are properly utilizing the battery
charger. However, if you use this battery charger to charge a large battery, such
as a marine deep-cycle battery that was not fully charged, you may not get the
battery's full capacity. Therefore, we do not recommend charging a large battery
with this unit.
NOTE: The maintain mode technology allows you to safely charge and maintain a
healthy battery for extended periods of time. However, problems with the battery,
electrical problems in the vehicle, improper connections or other unanticipated
conditions could cause excessive current draws. As such, occasionally monitoring
your battery and the charging process is required
BATTERY CHARGING TIMES
BATTERY
APPLICATION
SIZE
POWERSPORTS 6 Ah
32Ah
AUTOMOTIVE 300 CCA
1000 CCA
MARINE 50 Ah
105 Ah
Times are based on a 50% discharged battery and may change, depending on
age and condition of battery.
CHARGING TIME (hours)
2A 6A 8A 10A
6 2 1.75 1.5
15 5 4.5 4
12 4 3.5 3
30 10 8.5 7
15 5 4.25 3.5
33 11 9.5 8
• 14 •