schulink SC1344 Manual Del Usuario página 13

RING TERMINAL QUICK-CONNECT
The ring connectors permanently attach to the battery, providing easy access
to quickly connect the charger to your battery. This application is appropriate for
motorcycles, lawn tractors, ATVs and snowmobiles.
1. To permanently attach to a battery, loosen and remove each nut from the bolt
at the battery terminal.
IMPORTANT: Loss of vehicle settings can occur. Check vehicle owners manual for
specific information.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord. Take care to keep
the wires and plug away from metal and moving parts.
6. Plug the charger power cord into a live grounded 120V AC outlet.
12V ACCESSORY PLUG QUICK-CONNECT
Charge or maintain your battery without lifting the hood. NOTE: The charger itself
must be disconnected when the vehicle is in use.
1. Connect the end of the 12V accessory plug quick-connect to the charger.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the charger through the vehicle's open window.
4. Plug the charger power cord into a live grounded 120V AC outlet.
5. If the vehicle's ignition key has to be on in order for the accessory outlet to
supply/receive power, turn the key, without starting the engine. Consult your
vehicle owners manual for instructions on how to make the 12V outlet live,
without drawing excessive power.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the maintain mode
automatically after the battery is charged.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not
start and the digital display will show one of two messages. If the display shows
"CONNECT BATTERY", make sure the charger is connected to the battery and the
connection points are clean and making a good connection. If the display shows
"WARNING CLAMPS REVERSED", unplug the charger from the AC outlet, reverse
the connections at the battery, and then plug the charger back in.
• 13 •