TOYAMA TM2.6TS Manual Del Usuario página 10

NOTE:
During the water tests check the buoyancy of the boat, at rest, at its maximum load.
Check that the water level is sufficiently below the exhaust so that there is no water flowing
through the power, when the water rises due to the waves and the engine is not turned off.
ATTENTION:
•
Overloading the boat engine can cause severe instabilities. Do not install an outboard
with more power than the maximum rating on the boat's capacity plate. If the boat does
not have a capacity plate, consult the boat manufacturer.
•
Incorrect assembly of the outboard may result in hazardous conditions. For permanently
mounted models, your dealer or other person with experience in proper handling must
mount the engine. If you are mounting the engine, you should be trained by an
experienced person. For portable models, your dealer or other person with experience in
proper outboard assembly should show you how to mount the engine.
•
The information presented in this section is for reference only. Proper assembly depends,
in part, on the experience and specific combination of boat-motor.
HEIGHT ASSEMBLY
The outboard mounting height significantly affects boat performance and speed. If the
mounting height is too high, cavitation tends to occur, thus reducing propulsion. If the mounting
height is too low, the water resistance will increase, reducing engine efficiency.
Assembly the outboard so that the anti-collision plate is between the bottom of the boat and
a level 25 mm below it.
NOTE:
The optimal outboard height is affected by the combination of the boat, engine and the
intended use. Testing at a different height can help determine the optimal assembly height. For
more information, consult your TOYAMA dealer or TOYAMA for our SAC.
10