Technical Information; Installation Considerations - Hansgrohe Joleena 04772 Serie Instrucciones De Montaje

English

Technical Information

Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Max. flow rate
04771XXX, 04772XXX 1.2 GPM (4.5 L/min)
04773XXX
Hole size in mounting surface
04772XXX
04771XXX, 04773XXX
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The base plate is intended for use on a sink that
is drilled for a 4" (100 mm) centerset faucet.
Installation of the base plate on a sink drilled for
a single-hole faucet is optional. No additional
parts are necessary to install the faucet without
the base plate.
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
• This drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
2
20 - 75 PSI (0.14 - 0.5 MPa)
125 PSI (0.86 MPa)
158°F (70° C)*
0.5 GPM (1.9 L/min)
1⅜" (34 mm)
1¼" (32 mm)
1⅝" (40 mm)
or if this drain is too small for the hole in your
sink, please refer to the instructions
included with the sink. Some sinks include
special drain installation instructions and/
or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost
of a specialty drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops.
If your stops are a different size, purchase
adapters at your local plumbing supply
store or home center. Adapters are not
available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.