Cooling On/Off; Options - KitchenAid W10537977A Guía De Uso Y Cuidado

REFRIGERATOR USE
5. Press LOCK, under plus, to raise the set point, or press
OPTIONS, under minus, to lower the set point.
Save/Confirm Temperature Settings
When you have finished adjusting both the refrigerator and
freezer set points, press MEASURED FILL "Confirm" to save
the settings.
NOTE: To exit Temperature mode without saving changes, press
the ICE MODE button under Back at any time, or allow about
60 seconds of inactivity. The temperature mode will turn off
automatically and return to the normal screen.
When adjusting temperature set points,
use the following chart as a guide:
CONDITION:
REFRIGERATOR too cold
REFRIGERATOR too warm
FREEZER too cold
FREEZER too warm /
Too little ice

Cooling On/Off

Your refrigerator and freezer will not cool when cooling is
turned off.
To turn cooling off, press and hold the LOCK and
MEASURED FILL buttons at the same time for 3 seconds.
When cooling is off, "Refrigeration Cooling is Off" will appear
on the display screen as shown.
IMPORTANT: To avoid unintentionally locking the dispenser
or changing other settings, be sure to press both buttons at
exactly the same time.
A. Press LOCK and MEASURED FILL at the same time.
To turn cooling back on, press and hold LOCK and
MEASURED FILL for 3 seconds again. "Cooling is Off" will
disappear from the display screen.
20
TEMPERATURE
ADJUSTMENT:
REFRIGERATOR Setting
1° higher
REFRIGERATOR Setting
1° lower
FREEZER Setting
1° higher
FREEZER Setting
1° lower

Options

Press the OPTIONS button to open the Options menu and select
between Max Cool, Max Ice and Water Filter Status.
Press the ICE MODE button at any time to return to the Normal
screen.
Max Cool
The Max Cool feature assists with periods of high refrigerator
use, full grocery loads, or temporarily warm room temperatures.
To turn on the Max Cool feature, press the OPTIONS button
to enter Options mode, then press the LOCK button, under
Max Cool, to activate the feature. When the feature is on, the
Max Cool icon will appear on the dispenser display screen.
The Max Cool feature will remain on for 24 hours unless
manually turned off.
To manually turn off the Max Cool feature, press the
OPTIONS button to enter Options mode (unless you are
already in Options mode), then press LOCK again. When the
feature has been turned off, the Max Cool icon will disappear
from the dispenser display.
NOTE: Setting the freezer to a colder temperature may make
some foods, such as ice cream, harder.
Max Ice
The Max Ice feature assists with temporary periods of heavy ice
use by increasing ice production.
To turn on the Max Ice feature, press the OPTIONS button to
enter Options mode, then press the TEMPERATURE button,
under Max Ice, to activate the feature. When the feature is on,
the Max Ice icon will appear on the dispenser display screen.
The Max Ice feature will remain on for 24 hours unless
manually turned off.
To manually turn off the Max Ice feature, press the OPTIONS
button to enter Options mode (unless you are already in
Options mode), then press TEMPERATURE again. When the
feature has been turned off, the Max Ice icon will disappear
from the dispenser display.
Water Filter Status
Press FILTER STATUS to display the percentage of use remaining
in the water filter (from 100% to 0%
The water filter status lights will let you know when to change
your water filter.
ORDER FILTER (Yellow) - Order a replacement water filter.
REPLACE FILTER (Red) - Replace the water filter. Replacing
the disposable water filter will automatically reset the water
filter status tracking feature. See "Water Filtration System."
).
ALSO