Best WPB9 Serie Manual De Instrucciones página 10

MOUNT THE DUCT COLLAR
Fix the duct collar to blower discharge with 2
screws (3.9x9.5mm), the screws are located
in the Hardware Package (Fig. 9).
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by
a qualifi ed electrician in accordance with
all applicable national and local electrical
codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box (Fig.10).
2. Secure the conduit to the wiring box
through a conduit connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws.
Make sure that wires are not pinched
between cover and box.
MOUNTING SCREWS 3.9x9.5mm
WIRING BOX
COVER
- 11 -
FIG. 9
FIG.10