Install The Hood - Best WPB9 Serie Manual De Instrucciones

MOUNT ELECTRICAL PLATE
Fix the elctrical plate with 4 screws (3.9x9.5mm)
to the hood, the screws are located in the
Hardware Package (Fig. 5).

INSTALL THE HOOD

Remove the plastic protective fi lm from
all exterior surfaces, decorative fl ues and
fi lters, prior to fi nal installation.
1. Construct wood wall framing that is fl ush
with interior surface of wall studs (Fig. 6).
Make sure:
a) the framing is centered over installation
location.
b) the height and width of the framing will
allow the hood to be secured to the framing
within the dimensions shown in Fig.8.
2. Install the (2) 6 x 60mm screws for the top
of the hood at the locations shown in Fig.7.
Use the two upper keyhole slots, do not
completely tighten the screws.
3. Hang the hood onto the screws.
4. Secure (2) 6 x 60mm screws at the lower
locations of the hood. Tighten all (4)
screws.
Notes:
a. Minimum hood distance above cook top
must not be less than 24". A maximum of
36" above cook top is highly recommend-
ed for best capture of cooking impurities.
Distances over 36" are at the installer
and the users discretion; and if ceiling
height and fl ue lenght permit.
Ceiling
Duct
Height
Method
(Feet)
8
Ducted
9
Ducted
Hood Distance Above 36" High Cook Top (inches)
25 26
24 27
Mounting Hole Height Above 36" High Cook Top (inches)
38-5/8 39-5/8 40-5/8 41-5/8 42-5/8 43-5/8 44-5/8 45-5/8 46-5/8 47-5/8 48-5/8 49-5/8
37-5/8
36 35 34 33
48 47 46 45
MOUNTING
SCREWS
3,9x9,5mm
WOOD CROSS
SUPPORT BEHIND
DRYWALL
28 29 30
31
32 31 30 29
44 43 42 41
- 9 -
FRAMING BEHIND WOOD
CROSS SUPPORT
DRYWALL
32 34
33
27 26
28
39
40 38
FIG.5
FIG. 6
35 36
25 24
36
37