Publicidad
Idiomas disponibles
Idiomas disponibles
After unpacking the device, the pull-up bar can be brought to the desired length by
Step 1
sliding both ends of the center bar outwards and unscrewing the telescopic bars at
both ends.
Step 2
Make sure that both ends of the pull-up bar are extended by identical lengths. Try
pushing the red locking mechanism towards the center on both sides and turning it
in the direction of the arrow to test whether it clicks into place. If this is not the case,
the lengths of the two ends do not match and must be adjusted. Release the locking
mechanism again before you carry out the next assembly step.
When fastening onto the door frame, make sure that the arrows of the locking me-
Step 3
chanism point upwards and that the pull-up bar is in a perfect horizontal orientation
to the floor.
18
Publicidad
