Troubleshooting - A-iPower PWE2000 Manual Del Propietario E Instrucciones De Operación

MAINTENANCE

Troubleshooting

PROBLEM
Motor will not start.
Unit does not reach
high pressure.
Output pressure
varies from high to
low
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
POSSIBLE CAUSE
"OFF" (O) position.
Power cord is not plugged
in.
Electrical outlet does not
supply adequate power.
Tripped pressure washer
circuit breaker.
Power switch is ON
however gun trigger is not
squeezed ON.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough water supply.
Pressure Tip has not been
installed on wand assembly.
Not enough inlet water
supply.
Pump is sucking air.
Supply voltage below
minimum.
POSSIBLE SOLUTION
Set switch to the "ON" ( | )
position.
Plug in power cord.
Allow to cool, and restart unit.
With power switch ON, squeeze
the gun trigger which will engage
the AUTO ON switch.
Replace with a 1" (25 mm) or
5/8" (16 mm) garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source fully.
Add desired pressure tip to end
of wand.
clean water.
Turn water on fully. Check garden
hose for kinks, leaks or blockage.
are tight. Turn product OFF
and purge air from pump by
squeezing the trigger until a
steady stream of clean water
clean water.
Verify that only the pressure
washer is running on this circuit.
18