A-iPower PWE2000 Manual Del Propietario E Instrucciones De Operación página 21

MAINTENANCE
Troubleshooting continued
PROBLEM
Motor buzzes but fails
to run.
No water.
No Detergent
Wand Leaks
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
POSSIBLE CAUSE
Supply voltage below
minimum.
System has residual
pressure.
Voltage loss due to
extension cord.
Pressure washer not used
for long periods.
Residual friction among
components. Unit might
hum.
Water supply is OFF.
Kink in the garden hose.
Soap injector hose is not
properly submerged into the
detergent.
O-ring damaged
POSSIBLE SOLUTION
Verify that only the pressure
washer is running on this circuit.
Turn unit "OFF", squeeze
trigger on spray wand to release
pressure, then turn unit "ON".
Unplug any extension cords
attached and plug the unit
directly into the outlet.
Call customer service.
Disconnect water supply and
power ON for 2 to 3 seconds,
repeat couple times or until the
motor starts.
Turn ON water supply
Remove kink in garden hose.
Make sure hose is properly
submerged.
Replace o-ring. If this does not
correct the issue, call our toll free
customer service department at
1-855-888-3598
19