Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Front
Driver's side shown
Repeat for opposite side
Complete bracket installation by aligning M-1200
bracket with holes in rocker panel. Insert flange
bolt through each hole in bracket and thread into
rocker panel. Finger tighten bolts.
4
Install running board to brackets using hardware
provided in board kit. Refer to board installation sheet
for specific instructions.
Tighten bracket hardware after board has been
installed.
Repeat board installation for opposite side of vehicle.
3
PAGE
OF
12
10431
Rev A
Publicidad
Tabla de contenido
