Project Source 67210-1201 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
2. Install the faucet:
a. Remove the preassembled mounting nuts (C)
from the faucet (A) and place the base plate
(B) and the faucet (A) in position on the sink.
Note: If the sink surface is uneven, use silicone
sealant (not included) to create a watertight seal.
b. From under the sink, thread the mounting
nuts (C) onto the faucet (A).
c. Tighten the mounting nuts (C).
3. Remove the lock nut (G) from hose guide
(F). Mount the hose guide (F) into the
far-right hole in the sink. Secure the hose
guide (F) underneath the sink using the lock
nut (G) and hand tighten.
4. Install the side spray:
a. Insert the side spray (E) down through
the hose guide (F) and into the sink.
b. From underneath the sink, push the
preassembled hose connector (H)
(D).
c. Pull down moderately to ensure the
connection has been made.
If it is necessary to remove the hose, press
on the tabs and pull the hose connector (H)
down.
2
C
3
4
5
4
A
B
F
G
E
F
D
H
Lowes.com
®