What If There Are Problems; Disposal; Technical Specifications; Warranty/Service - Beurer MG 280 Instrucciones De Uso

10. What if there are problems?

Problem
The device's 7 air
chambers do not
inflate.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the
end of its service life. Dispose of the device at a suitable local collection or recycling
point in your country. Dispose of the device in accordance with EC Directive – WEEE
(Waste Electrical and Electronic Equipment). If you have any questions, please contact
the local authorities responsible for waste disposal.

12. Technical specifications

Mains operation:
Input
Output

13. Warranty/service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") pro-
vides a warranty for this product, subject to the requirements below and to the extent described as
follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations
which ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused
product from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively
for personal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality
in accordance with the following provisions, Beurer shall carry out a repair or a replacement deliv-
ery free of charge, in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the
first instance: see the attached "International Service" list of service addresses.
Cause
The mains part is not plugged
into the device
The device turns itself off
automatically after the
15-minute programme
duration (automatic switch-off)
100-240 V~, 50/60 Hz, 0.8 A
12 V 3.0 A
Solution
Plug the mains part into the device and
turn on the device using the ON/OFF
button
Turn on the device again using the
ON/OFF button
20