Cleco MP2464 Manual De Instrucciones página 3

Manufacturer:
Apex Tool Group, LLC
670 Industrial Drive
Lexington, South Carolina 29072, USA
Importer:
Apex Tool Group GmbH
Industriestraße 1
D-73463 Westhausen, Germany
For this Instruction Manual
The original language of this instruction manual is English.
This Instruction Manual is intended for all persons who will
operate and maintain this equipment.
Symbols on product
Be sure you understand their meaning before using this
equipment.
-------------------------------------------------------------
Read all instructions
-------------------------------------------------------------
Eye protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
Ear protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
CE compliant
-------------------------------------------------------------
1 Safety:
-------------------------------------------------------------
Indicates a potentially hazardous situation
for personal health and safety. If this warning
is not observed, death or serious injury may
occur.
-------------------------------------------------------------
Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury or property and environmental
damage.
-------------------------------------------------------------
Speed check
Using a tachometer, check the tool speed weekly or with
every 200 hours of operation to assure it does not exceed
the rated speed of the tool at 90 psig.
EN
Personal protective equipment
Exercise caution, pay attention to what
you are doing and act reasonably at all
times when working with a pneumatic tool.
Never use a pneumatic tool while under the
influence of drugs, alcohol or medication.
One moment of inattentiveness in the use of
a pneumatic tool can cause serious injuries.
General Safety Instructions
Designated Use
A pneumatic assembly tool is to be used only for tightening
of threaded joints or running down fasteners using industrial
power tool type drive sockets or bits.
Do not modify the tool, any guard, or accessory unless
approved in writing by Apex Tool Group, LLC.
Any abuse or misue of this tool or the abrasive
can be extremely dangerous. The abrasive
used with this tool are not manufactured or
supplied by Apex Tool Group, LLC. Consult
and comply with the safety practices provided
by the abrasive manufacturer.
Air Line Lubrication:
Part No. Packaged
540397 1 Quart (0.94 liter)
533485 1 US Gallon (3.78 liter)
Air Supply Line:
Parameter
Minimum inside diameter: 1/4" (6.35mm)
Air Hose
Maximum length: 8.0' (2.4 m)
Working
Performance rated at: 90 psi (620 kPa)
pressure range
Air quality according to ISO 8573-1, quality
Compressed air class 2.4.3
The compressed air must be clean and dry.
Disposal:
Observe local disposal guidelines for all
components of this tool and its packaging.
Copyright protection:
Apex Tool Group, LLC reserves the right to modify,
supplement or improve this document or the product without
prior notice. This document may not be reproduced in any
way, shape or form, in full or parts thereof, or copied to
another natural or machine readable language or to a data
carrier, whether electronic, mechanical, optical or otherwise
without the express permission of Apex Tool Group, LLC.
Page 3
PL15-2464-LG1
05/18/2018
Designation
Airlube 10W/NR-420LB DR
Airlube 10W/NR-420LB DR
Description