Uline H-1619 Manual De Instrucciones página 3

MACHINE PLACEMENT
Place the Automatic Stretch Wrap Machine close to an
area where you will be wrapping your pallet loads. Make
sure that there is sufficient room to load/unload the
machine and that you do not stretch the wiring cable.
Remember, you will need to provide electrical service to
a 120 VAC, 15-AMP outlet.
FLOOR WEIGHT BEARING TOLERANCE
The floor must be able to bear the weight of the
machine, the weight of the maximum load, plus a safety
factor. The floor must also be able to tolerate the stress of
the machine's operation. If fork trucks will operate on the
same weight bearing area, add the weight of the trucks
to the weight bearing stress tolerance requirements.
PAGE 3 OF 33
SySTEM SET-Up
MACHINE SET-UP
1. Place skidded machine close to the designated wrap
area. Remove all shipping fasteners holding the
machine to the pallet. The machine may be crated
with the tower tilted down and the motor cover front
carriage roller removed for shipping purpose.
2. Place forks of the forklift through the tubes provided
at the rear base of the module, remove the machine
from skids and place it at the designated wrap area.
3. If the OPTIONAL ramp (H-1676) is purchased: Select a
ramp position as illustrated below. The ramp can be
positioned anywhere in a 180° rotation around the
front of the turntable. There should be a 1/4" gap
between the turntable and the ramp. The ramp
should be fully supported by the floor. (See Figure 1)
180˚
Figure 1
1/4" Gap
0913 IH-1619