For Your Safety; General Safety Statements - Dräger UCF 6000 Instrucciones De Uso

1

For your safety

1.1

General safety statements

Before using this product, carefully read the instructions for use.

Strictly follow the instructions for use. The user must fully

understand and strictly observe the instructions. Use the product
only for the purposes specified in the Intended use section of this
document.
Do not dispose of the instructions for use. Ensure that they are

retained and appropriately used by the product user.
Only trained and competent users are permitted to use this

product.
Comply with all local and national rules and regulations associated

with this product.
The thermal imaging camera is maintenance-free. However, it

should be inspected for proper functioning on a regular basis. Only
trained and competent personnel are permitted to inspect the
product as detailed in these instructions for use (see Chapter 5.2
on Page 49). Maintenance work which is not described in these
instructions for use only must be carried out by Dräger or by
specialized personnel trained by Dräger.
Use only genuine Dräger spare parts and accessories, or the

proper functioning of the product may be impaired.
Do not use a faulty or incomplete product. Do not modify the

product.
Notify Dräger in the event of any component fault or failure.

Electrical connections to devices which are not listed in these

instructions for use should only be made following consultation
with the respective manufacturers or an expert. If other
components are used, the intrinsic safety of the camera may be
compromised.
Dräger UCF 6000, UCF 7000, UCF 8000, UCF 9000
Devices or components for use in explosion hazard areas which

have been tested and approved according to national, European
or international Explosion Protection Regulations may be used
only under the conditions explicitly specified in the approval
documents and under consideration of the relevant legal
regulations.
If the camera is marked for group I (mining), it may be used in

applications where coal dust can be deposited in layers. The
maximum surface temperature of the camera is 130 °C (266°F)
even if a device fault should occur.
Any type of chemical based markings or paint on the device may

compromise the device safety. Dräger recommends encoding any
markings in the welcome screen. More detailed information can be
found in the online help of the PC software.
For your safety
29