EN
Instructions
IMPORTANT:
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
• YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A
Release BOTH storage clips.
B
Open out the stroller.
C
Using foot, push BOTH footplates down fully to engage the primary
locks.
WARNING: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
A
TO ENGAGE BRAKES: With foot, push down the ON lever.
B
TO RELEASE BRAKES: Push down on BOTH brake levers.
Parking device shall be engaged during the loading and unloading of children.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A
TO LOCK SWIVELS: Align front wheels and press down on locking
levers.
B
TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: Avoid serious injury from falling or sliding out. Always use the crotch
strap in combination with the waist belt and shoulder straps.
TO FIT HARNESS:
A
Insert both fasteners securely into clasp.
B
Adjust strap lengths by sliding buckles. Belt and harness should be snug.
C
'D' rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D
Squeeze fastener prongs and pull apart.
5 TO ADJUST SEAT RECLINE
A
TO RECLINE SEAT BACK: Lift both hand grips to release seat locks and
recline the seat back to desired position.
B
Lower hand grips to engage locks on both sides.
C
TO RAISE SEAT BACK: From rear of stroller push seat back to original
upright or desired intermediate position.
6 ATTACHING THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum carrying capacity of hood pouch - 1.1 lb (0.5kg.) per pouch.
A
With stroller open, clip the hood to the handle tubes just above the
retaining rivets.
B
Place the rear apron behind seat backs and attach poppers.
C
Extend hoods and press down on both side hinges of each hood to lock
open.
D
Lower flip-down visor if required.
E
The hood is removed by firmly pressing down the hood release tabs.
7 TO FIT THE RAIN APRON
A
Ensure visors are folded away beneath the hood.
B
Place the apron over the hood.
C
Attach two eyelets (one each side) to the hood clips.
D
Attach two eyelets (one each side) to the front legs.
8 TO OPERATE THE LEGRESTS
TO EXTEND THE LEGRESTS: Feel through seat corner openings. Locate sliders
and pull forward. Reverse this process to retract legrests.
9 TO FIT THE SHOPPING BAGS
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4lb (2kg) evenly distributed.
The stroller may be folded with the bag still attached but all contents must be
removed. Failure to do this could damage stroller and contents of shopping bag.
A
Place bags on the 'X' frame under seat with lowest edge of bag at front.
B
Attach front straps to front legs just below seats.
C
Attach rear straps to rear legs just above horizontal tie bars.
10 TO FIT THE HEAD HUGGERS
Unclip shoulder straps from seat belt clasp and feed straps through holes in
head hugger fabric (height can be adjusted by selecting upper or lower
holes).
Reclip shoulder straps to set belt clasp.
11 TO FIT THE BOOTS
A
Place boot over seat base and thread crotch strap buckle through slit in
boot.
B
Attach poppers to seat sides.
12 REMOVING AND REFITTING THE SEAT COVERS
Remove rain apron, hood, boots and head huggers from stroller if fitted.
A
Twist shoulder strap end buckles and feed through holes.
B
The waist harness back strap is fixed to the chassis behind the seat.
To remove, twist the buckles on each end of the harness back strap and
unthread from the 'D rings attached to the chassis. IMORTANT – It is
important that the strap be rethreaded through the 'D' rings after the
seat has been refitted. Failure to do so will endanger your child.
C
Unclip seat cover retaining straps.
D
Unfasten seat fabric from handle tubes and seat base.
E
Slide fabric from seat back and base.
F
When refitting seat fabric, insert seat back support tubes into fabric fold.
G
When refitting seat fabric to seat base, loop fabric flap over legrest strap
and pass crotch strap buckle through both holes in seat fabric and then
hole in seat base.
H
When refitting shoulder straps, choose the fabric holes appropriate to the
child's size. Twist the buckles and feed through seat fabric and then
through holes in seat back arms.
13 TO FOLD THE STROLLER
Ensure visor is folded away beneath the hood.
Ensure the seat back is in its fullest upright position and the hood (if fitted) is folded
back.
Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the stroller.
A
Ensure the seat backs are in the fullest upright position.
B
Fold back the hood (if fitted).
C
Using foot, lift up BOTH footplates to release primary locks.
D
Push down on secondary lock lever.
E
Grip handles and push forward.
F
Compress folded stroller and engage BOTH storage clips located on each
side of the stroller.
3