4
Push
button.
5
Push
button to complete the setting.
NOTE
• When other electric appliances are used at the same time, to avoid triggering the circuit breaker, power saving mode
is recommended. Of course you can use power saving mode to save energy as well.
• Power saving mode consumes less energy, but may not heat / cool the room as much as normal mode. (The
maximum current is limited to approximately 75 % (factory default) of the normal mode.)
• To adjust the power-save settings, see "To configure the power saving settings" in Power saving mode.
• Even when operation start / stop, operation mode change, or power reset is performed during the power saving mode,
the power saving mode is retained until the next operation.
7
Maintenance
WARNING
Cleaning the air filter and other parts of the air filter involves dangerous work in high places, so be sure to have
a qualified installer or qualified service person to do it.
Do not attempt it by yourself.
Cleaning air filters
Clogged air filters will reduce the cooling and heating performance.
1) If "
" is displayed on the remote controller, clean the air filters.
2) When the cleaning of air filters has been completed, push
"
" disappears.
When not used for a long time
1. Perform the fan operation for a couple of hours to dry inside.
2. Push
button on the remote controller to stop running, and turn off the circuit breaker.
3. Clean the air filters and reinstall them.
Before the cooling season
Clean the drain pan
• Contact the dealer where you purchased the product.
(Drain does not work if the drain pan or vent is clogged. In some cases the drain may overflow and wet the wall
or floor. Clean the drain pan before the cooling season.)
Check periodically
• If the unit is used for a long time, parts may deteriorate and cause malfunction or bad drainage of dehumidified
water depending on the heat, humidity, or dust.
• In addition to the usual maintenance, it is recommended that you have the unit checked and maintained by the
dealer where you purchased it.
65-EN
– 33 –
(1)
button.
(2)
NOTE
For environmental conservation, it is strongly recommended that the indoor and outdoor units of the air conditioner in
use be cleaned and maintained regularly to ensure efficient operation of the air conditioner.
When the air conditioner is operated for a long time, periodic maintenance (once a year) is recommended.
Furthermore, regularly check the outdoor unit for rust and scratches, and remove them or apply rustproof treatment, if
necessary.
As a general rule, when an indoor unit is operated for 8 hours or more daily, clean the indoor unit and outdoor unit at
least once every 3 months. Ask a professional for this cleaning / maintenance work.
Such maintenance can extend the life of the product though it involves the owner's expense.
Failure to clean the indoor and outdoor units regularly will result in poor performance, freezing, water leakage, and even
compressor failure.
Maintenance List
Part
Unit
Check (visual / auditory)
Heat exchanger
Indoor / outdoor
Dust / dirt clogging, scratches
Fan motor
Indoor / outdoor
Sound
F
t l i
r e
n I
d
o
r o
D
u
s
/ t
i d
, t r
b
e r
a
k
a
g
• Vibration, balance
F
a
n
n I
d
o
r o
• Dust / dirt, appearance
Air intake /
Indoor / outdoor
Dust / dirt, scratches
discharge grilles
Dust / dirt clogging, drain
Drain pan
Indoor
contamination
Ornamental panel,
Indoor
Dust / dirt, scratches
louvers
• Rust, peeling of insulator
Exterior
Outdoor
• Peeling / lift of coat
Maintenance
Wash the heat exchanger when it is clogged.
Take appropriate measures when abnormal
sound is generated.
• Wash the filter with water when it is
e
contaminated.
• Replace it when it is damaged.
• Replace the fan when vibration or balance is
terrible.
• Brush or wash the fan when it is contaminated.
Fix or replace them when they are deformed or
damaged.
Clean the drain pan and check the downward
slope for smooth drainage.
Wash them when they are contaminated or apply
repair coating.
Apply repair coating.
66-EN